Janam XM66 - Example of registry entries to set Scan properties
ScanWedge settings can be preset via .reg files. The following example shows how to preset UPC-A bar code properties to:
a. disable transmit check digit.
b. disable numeric return digit.
Place the two attached .reg files in \application folder, and
do a hard reset as follows:
1. Remove the battery door from the back of the unit.
2. Locate the reset button.
3. While holding the arrow-up key located on the keypad, use the stylus to press
the reset button (once). Continue to hold the arrow-up key.
4. After the reset has occurred and the calibration screen appears on the screen,
release the arrow-up key.
a. disable transmit check digit.
b. disable numeric return digit.
Place the two attached .reg files in \application folder, and
do a hard reset as follows:
1. Remove the battery door from the back of the unit.
2. Locate the reset button.
3. While holding the arrow-up key located on the keypad, use the stylus to press
the reset button (once). Continue to hold the arrow-up key.
4. After the reset has occurred and the calibration screen appears on the screen,
release the arrow-up key.